Shipbucket
http://www.shipbucket.com/forums/

Caledonia??
http://www.shipbucket.com/forums/viewtopic.php?f=14&t=6340
Page 10 of 28

Author:  reytuerto [ March 19th, 2018, 10:39 pm ]
Post subject:  Re: Caledonia??

Good afternoon, Heuhen:

One question, What kind of propulsion you are using for your Legend class frigate? Is it a kind of waterjet? Thanks and cheers.

Author:  heuhen [ March 20th, 2018, 8:25 am ]
Post subject:  Re: Caledonia??

reytuerto wrote: *
Good afternoon, Heuhen:

One question, What kind of propulsion you are using for your Legend class frigate? Is it a kind of waterjet? Thanks and cheers.
Simplified explanation: yes! Sort of

The more advanced explanation, I do not have the link for it, Erik- might have. But I am going for an simplified version.

Note: what can't be seen on the drawing, is that there is an small propeller ducked in-between both "trusthers" for low speed operation

Author:  erik_t [ March 20th, 2018, 3:10 pm ]
Post subject:  Re: Caledonia??

I assume heuhen refers to the AWJ-21, about which more here: (PDF)

About the speed, I am highly skeptical (perhaps possible, but hugely expensive for no good reason).

Author:  heuhen [ March 20th, 2018, 3:14 pm ]
Post subject:  Re: Caledonia??

erik_t wrote: *
I assume heuhen refers to the AWJ-21, about which more here: (PDF)

About the speed, I am highly skeptical (perhaps possible, but hugely expensive for no good reason).
Thanks!

Speed: I wasn't 100% sure about it either, I was debating with my self, either 32-33 knots or 35-36 knots, I have changed it back to 32 knots

Author:  Morten812 [ March 20th, 2018, 3:45 pm ]
Post subject:  Re: Caledonia??

The aft chaff-launcher on top of the hangar is missing on the topview?

Author:  heuhen [ March 20th, 2018, 3:59 pm ]
Post subject:  Re: Caledonia??

Morten812 wrote: *
The aft chaff-launcher on top of the hangar is missing on the topview?
ups!

Author:  heuhen [ April 28th, 2018, 5:50 pm ]
Post subject:  Re: Caledonia??

Juno class

Multi Mission support ship.

The Navy wanted a support ship, that could assist in other operation. But in the end she was most of here time used as a fleet tanker, and very rarely used in other type of support mission.

Juno class was basically equipped and constructed after commercial standards, but are designed to operate at speed up to 27 knots, thanks to Navy's most powerful turbine, the J5-class turbine, with the addition of 2 large diesel engines. with a full size hangar with workshop and manufacture capability and fully equipped hospital with space for 100 patients. A Ro-Ro deck and container deck and 6 seperate fule tanks for aviation fuel and ship fuel, she was capable give most ships and land recourse service.

-------------
Juno class
Multi mission support vessel (fleet tanker)
build: 3
planned: 4
-------------
Displacement: 42000+tons
Lenght: 207 meters
Beam: 28.9 meters
draft: fully loaded: max: 11,5 meters
propulsion: CODELOD, 1 X 42.000 hp turbine, 2 X 15.000 hp diesel engine, 6 Diesel generators, Battery bank
Speed: Test speed 29,2 knots, normal operation max speed: 27 knots
Range: 20000 Nm

Capacity:
- Tanks for diesel oil, aviation fuel, fresh water
- Lubrication oil stored in tanks and drums
- Stowage for up to 35 × 20 containers

Complement: 55 + 50 non crew, additional space for up to 100 personnel/passengers (300+ when converting ro ro deck)

Armament:
- 1970's 56 mm cannon
- several stored railing mounted machine guns

Aircraft facility: 1 large helicopter and 2 medium helicopter with fully equipped repair facility and limited production of parts capability, after 2020; limited 3D printing capability.


[ img ]

Drawing updated:

- enlarged the flight deck by a couple of meters
- increased the hull depth with around a meter.
- increased the hull high above water by some
- added a "sort off" beam around the center of the ship right under the ramp, to give better protection toward the dock when she is docked, but also as an part of the hull strength.
- gave the bulb a minor face-lift... literally... I lifted it up a couple pix.
- added and adjusted minor details.

update V.2:
- added additional beam, after ace. suggestion. with some addon

If someone have a better propeller...

Author:  Ro-Po Max [ April 28th, 2018, 6:47 pm ]
Post subject:  Re: Caledonia??

Good job!!! :D

Author:  erik_t [ April 28th, 2018, 6:51 pm ]
Post subject:  Re: Caledonia??

That Chinook flight deck looks somewhat alarming. Very attractive otherwise.

Author:  heuhen [ April 28th, 2018, 7:17 pm ]
Post subject:  Re: Caledonia??

erik_t wrote: *
That Chinook flight deck looks somewhat alarming. Very attractive otherwise.
how big should it be, I can move the structure more forward, to make the deck bigger, or just enlarge the aft portion of the hull, by some meters. thanks

Page 10 of 28 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/