| Shipbucket http://www.shipbucket.com/forums/ |
|
| A question http://www.shipbucket.com/forums/viewtopic.php?f=5&t=9910 |
Page 1 of 1 |
| Author: | maxwell john [ June 29th, 2020, 1:52 pm ] |
| Post subject: | A question |
Perhaps this seems silly as a question, but I am kinda new here so I'm asking anyways. For the parts sheets, when taking the parts to use in drawings can you just snip the individual part you need? Or is their a way of copying each part separately to add to a drawing. Thank you! |
|
| Author: | Cargil48 [ June 29th, 2020, 6:47 pm ] | ||
| Post subject: | Re: A question | ||
Perhaps this seems silly as a question, but I am kinda new here so I'm asking anyways.
I for my part I download the entire sheet using Paint, name it according to its title and save it where I find it appropriate. Then, using Paint again for a drawing, I get to "Open" to open that specific sheet and outline the part I want to copy for pasting in my drawing. Did it help?
For the parts sheets, when taking the parts to use in drawings can you just snip the individual part you need? Or is their a way of copying each part separately to add to a drawing. Thank you! |
|||
| Author: | maxwell john [ June 29th, 2020, 6:48 pm ] |
| Post subject: | Re: A question |
Ah yes it does! Thank you very much |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|